Dry cleaning in the car wash is great, but expensive. If you have time, it is better to remove in the car ourselves. To help you will be a remedy for two basic ingredients - soap and water. This must be a concentrated solution, since the large alkali content contained in soap can dissolve fatty acids - spots on seats and plastic surfaces. The weak solution will not cope with mud, and water is absorbed into the upholstery, which can lead to the appearance of mold.
How to prepare a solution
It is better to choose an economic soap - there is a larger percentage of free alkali, and accordingly, a hydrogen indicator, familiar to you under the abbreviation of the pH, is only 11-12. You can take baby soap or liquid soap, if you do not need to remove the contaminated pollution, and it is enough to make a wet cleaning and remove tracks from the oily fingers from the steering and the instrument panels.
Soap solution should be without cutting
Photo: unsplash.com.
So, proceed. Sutitate soap on a shallow grater or cut it into pieces. Put the chips into the deep plate and add some water, mix. Then send to the microwave for 30-45 seconds. Soap will be softer, so then it will dissolve faster in water. Pour the liquid into an empty bottle with a pulverizer. Shake well to dissolve soap. Ready!
How to use a soap solution
Spray the solution over the entire surface of the fabric. If the upholstery of the seat is made of leather, go through it with a soft cloth with a small pressure. If the seat is fabric, you can use a brush for cleaning suede shoes with rubberized bristles - it will clean the stains, but does not damage the integrity of the tissue. Then it is worth it to make more money on particularly dirty places. You can cover them from above the shiny side of the foil - take off the piece from the roll and put on top. Foil does not give heat to leaving the chemical response of fat neutralization by alkali, and therefore the dried spot will faster soften, and it will be easy to remove it.
The soap contains alkali - when adding water, it enters into a reaction with fatty acids
Photo: unsplash.com.
What to do after
Load the seats with paper napkins and push them so that the fabric gave moisture. Wipe the panels with a dry absorbing napkin from the microfiber. You can apply over a bit of the air conditioner so that the dust is slower than the surfaces.